Free Energy - Freie Energie - energia libre - OverUnity.com

Tito, don't worry: All Mothers Go To Heaven. I've buried mine four years ago. And I pray for all Mothers. For your too; I'm a Catholic, like you are. 

Tito, I'm sorry to here about the loss of your mother. I will keep both of you in my prayers. God bless, John

Sir Tito,
      Condolences to you and your family, i know that she's with GOD right now...

Tito has lots of good friends.  ;]

I did some stuff last night, and low power, 5v with resistors had shown little if any output, 200mv at best, at low freq pulse.
Got rid of the resistor and added a large inductor and a diode in series with the battery to have an igniter circuit to raise the voltage of a cap for discharge. The output is still nill. My probescope shows a very high freq ring that is short lived.

So then I removed the short on the series bifi and used a .1uf 250v cap there instead. Now we have sound!. The transformer pops err clicks when pulsed with straight 5v with parallel cap for oomph. With just hand speed on rotor switching reed, and getting over 5v out(remember it is a step down transformer winding) and the ring is much better. Did these last tests at lunch here today. Will check the freq and such tonight.  The outer green winding(primary) didnt even get warm and it is 1.1ohm with 5v in. Probably the other 2 bifi windings absorb heat from the primary winding. Will see with longer runs.

Next is to get the input to pulse at the freq of the ring and see what happens.

Thanks Tito for your tips and hanging around as long as you did. Prayin for ya. ;]

Mags

keep it up Mags! and nice primitive scope u got there... just kidding...

Also is your magnetic path closed, in other words are you using a toroid, or some other closed magnetic path.
Lets look at the shorted coil on a toroid and a solenoid
Look at Leedskalnin's pmh it has a closed path magnetic field, as long as the magnetic field is not broken the electric field orbits the coils but as soon as the path is broken(solenoid configuration) the electric field callapses into the coils.
You want a standing electric field this brings the aether to your device sets it in motion and charges the field, then you have a standing field to draw from, if you want alot of water you go to a pond you dont set a bucket in the rain.

Hey Dave

Thanks for the input.  I am using an E core for this transformer.

Tito once talked about coils perpendicular to each other. Would this have anything to do with the electric fields effect between the coils?


Really, I dont know if this this is going to work till I try try try.  Im putting together a 556 timer circuit where one of the timers in the chip is freq and the other will be a one shot with adjustable duty cycle. Need to be around 40khz. And the one shot needs to be a much faster pulse(on time) than 1 cycle at 40khz.

Hopefully we see something. Due to possible drift of the circuitry, I want to figure a way to trigger the one shot from the natural freq of resonance of the bifi oscillation. Some sort of peek detector.

Tito had mentioned zener diodes. Once he said at least 3v zener. But I dont see what or where to use it. One direction the zener conducts at less than 1 volt and the other direction at 3v. Hadnt figured a use for that yet.

Mags

There's a patent on a crystal radio that powered itself and the only prerequisite to make the device work  was that the coils be perpendicular to each other. I mapped the electric field around the solenoid coils this is what it looked like, in the radio he had only two coils but I carried it a little farther to get the point across and to help me visualize it.
I make these images to help me learn, and a picture is worth a thousand words.

Something else that is of interest is the way these magnetic forks in an alternator loop around and bring the magnetic field into the plane of the electric field, Im sure this would boost both fields.