Hmm. So why not use the car chassis as an alternative ground? What properties of the battery enable it to be a ground alternative, but the car chassis not?

Mags

I would say to ger high negative charge

I would say to ger high negative charge

But think about this...

Say we have 2 identical batteries. If we connect an LED to the neg of one battery and to the positive of the other, does the led light? Or even try with caps. Light? 

Mags

Mags

yes! the properties of the battery enable it to be a alternative negative common ground. Tito tell the truth.
but, nobody can tell how the used electrons get energy again when they return back from the middle way(like a U turn)

I believe that if OU exists, that the circuits dont necessarily need to draw upon external electrons to have excess power per input.  What if the output to load is a loop? Would adding more electrons to that loop provide more power than we input? Or could it be a special mechanism(electronic) that we are missing that can make the power in that output loop greater than the input.

If an earth ground is needed or used, there must be a way to us looping instead. Because all we are doing is using the earth for currents to flow from one end of the circuit. And if there is current flowing in and out of the circuit via the earth ground, then there must be another end of the circuit(ant, or remainder of circuit in air) that has current flowing in and out also in the opposite direction.

So why cant we just loop these 2 ends of the circuit?

I think. 

Mags

I emabrrased. By mistake I took live wire connected to my circuit via transformer and the second end of primary O connected to my garden water pipe. It was working fine ! No need to use neutral wire at all.... I know that here in Europe somewhere the neutral wire is connected to ground wire but the point is that my garden water pipe is connected to my well via iron pipes and is located 20m from my house. What is going on ?
I tried it with inverter but it doesn't work at all.
I don't understand ground  , is that filled with current from all houses around ?

hey buddy don't forget that the chasis of a car is also connected in the negative pole of the battery right? 


Now, i don't know exactly the correct word for it but the closest is the "buffer effect or a scratch" that is the use of the battery.


and that is the way i see it. 
AND IN THIS MANNER ALSO, I DON'T SEE A REASON WHY A BATTERY WILL NOT LAST LONGER? AM I RIGHT QWERT? 


The reason why battery is used, it is because there is a pulling action with the two pole. did you get that ladies and gentlemen? 


so that when a signal is detected in the antenna, then the electron in the negative pole will react to the proton made by the signal.


so then after that, the electron will go back to the negative pole of the battery because of the pulling effect of the protons in the other side of the battery. Did you get it again class?        


And That is the truth happening  to that thing. 


Bye  HOPE IT CAN HELP TO EVERYONE 


GOD BLESS YOU ALL!!!


MERRY CHRISTMASS AND HAPPY NEW YEAR!!!!!!!!




ALWAYS REMEMBER: A THOUSAND STEPS START WITH THE FIRST 

UP TO NEXT EPISODE EVERYONE, I'M SO EXCITEMENT HAHAHAHHAHAHAHAHAHAHA LOL


TITO L. ORACION 

Soooo, we put a 1.8 meter antenna on the batt positive, and the neg works as a ground?

Mags

I think antena on tthe negative through capacitor

"I took a 12 Volt battery and connected its positive terminal to one end of an LED bulb with enough series protection resistor. Then I connected the other end of the LED bulb to earth (soil with moisture outside my house). I did not connect the negative terminal of the battery to anything. I expected the bulb to glow, but it did not glow until I connected the negative terminal of the battery to the ground as well." This is apparently how Imtotob completes his circuit as stated by him in :18 seconds of his video. He registors zero amp draw! It's important to note that you can't use the same point for the battery Earth Ground! You need two different Earth Grounds! This completes the circuit. The voltage differential between the grounds generates the transverse oscillation in the standing wave!

Here's a good video on the electrical circuit by Bill Nye:

http://www.youtube.com/watch?v=rg-XFXdtZnQ

At 1:40 of Bill Nye's video, he closes a blade switch on a battery and bulb in series, and shows the current runnng from the negative side of the battery through the bulb then into the positive pole of the battery. Just the opposite of what anyone else will tell you. Further they disscect a battery and show a carbon rod dieletric semi conductor core, connected to the positive node of the battery. The carbon core is inside an aluminum conductor cup connected to the negative side, with a chemical electrolite in between.
 
The Earth's molton iron core is rotating faster then the crust, like the roter in an electrical generator. Giga-watts are bled off to form the Earth's protective Electro Magnetic Field every second.
 
A carbon core is the positive dielectric or insulator core.  This material is electron vacuuous, and Power generated from the Earth's spinning Iron core flows into this electron deserted positive ground, through the LED and back into the second seperated groind exciting the crystal while completing the circuit. The light DIODE allows the fluctuating ground field to pass in one direction only to comple the circuit.  The current passes at a kilohertz frequency.
 
With the current not flowing, but standing still, a traverse oscillation vibrates the standing sine wave on the lateral plane. At 1.59 Khz, the constant oscillating frequency of magnatisem. This vibration is the same along the Bloch Wall in every permanent magnet. This is a natural phenomenon. and excites the crystal in the LED and lightes it up with zero amp draw. The standing oscillation and current flow dovetail to cause flickering in the bilb. The message from the Bill Nye video is that negative and positive are labeled backwards!