Author Topic: Selfrunning Free Energy devices up to 5 KW from Tariel Kapanadze (Read 2014021 times)

ElectricGoose · « **Reply #8730 on:** November 13, 2011, 11:56:20 PM »

This method will not result in OU.

Just shows...shouting from the rooftops "OU OU!!!" does not result in OU...only people looking like buffoons. Funny...I thought it was 15w in and 150watts out???!. Obviously not (as previously stated). Just imagine..all that SUPPOSED OU and you still can't self run a light. At some stage be honest with yourself and let the evidence smack some sense into you!!

Time to take that video down off the home page also Stefan. It slows the site and its downright annoying listening to it.

As Cosmo stated....Wesley has no idea. This method has nothing to do with kapanadze and you are seeing an illusion of OU only.

Free Energy - Freie Energie - energia libre - OverUnity.com · « **Reply #8730 on:** November 13, 2011, 11:56:20 PM »

Sponsored links:

baroutologos · « **Reply #8731 on:** November 14, 2011, 12:46:20 AM »

Quote from: verpies on November 13, 2011, 10:55:30 PM

I agree, the ferrite halves should be joined together but not glued together.
Preferably joined with a minimal air gap (paper gap) just like on the inventor's working device.

That ferrites should not be constrained has been known for a long time.
See the 2nd page of the document below (look for the phrase "ferrite bead gotcha"):
http://www.epanorama.net/sff/Power%20Electronics/Uninterruptible_Power_Supplies/Shields%20and%20Sheilding.pdf

@itsu
Do not be so quick to reach the conclusion that you are seeing the resonance of the LF 15turn coil.
Wind the other HF 50-turn coil and compare the frequency peaks between these two coils when they just feed the scope probe.

RLC circuits practically do not resonate when no current flows in them (when resistance (R) is very high) and your scope probe has R in the mega ohm range.
However, an inductor/coil shorted by a low ESR capacitor is a wholly different story (even if the the capacitor has only several picofarads)...

Stimulating thinking Verpie.

It made me take a look at o-scopes probes composition. http://en.wikipedia.org/wiki/Test_probe
Probes as the article say have a large resistance but this is shunted by a capacitance. So indeed a current will flow.

Then took measurements of mine o-scope. (old Hitachi V-212)
Probe either in x1 or x10 shows an infinity (above 20M) resistance either working or not, whereas it has some x1 90pf and at x10 15pf capacitance.

So in measuring any RLC circuit, i would personally connect o-scope at x 10 probe mode (compansating with adjustments) and taking into consideration that 15pf capacitance (in my case) added to the examined circuit. Avoid the x1 probe due to huge capacitance.

Free Energy - Freie Energie - energia libre - OverUnity.com · « **Reply #8731 on:** November 14, 2011, 12:46:20 AM »

Haan · « **Reply #8732 on:** November 14, 2011, 12:56:45 AM »

Quote from: verpies on November 12, 2011, 05:19:48 PM

... the bilfilar coil connected in bucking mode (back-to-back serial opposing) and AAW's configuration seems to use the bilfilar coil connected in serial reinforcing mode.

Please explain what "bucking mode (back-to-back serial opposing)" and "serial reinforcing mode" mean.

aether22 · « **Reply #8733 on:** November 14, 2011, 01:12:33 AM »

I have been super busy the last 4-5 days and had no real chance to keep up to date with this, however I think I now understand why T-1000, Wesley and others are giving great detail on some things such as basic construction of the transformer and tuning.

And why they hadn't given (at least hadn't when I stopped reading) any real info on what else is required.

They want us to not know how to build the circuit so we have to try lots of stuff to see what works, and in the proccess improve on the design.

I think they aren't interested in straight reproduction, they want experimentation.

At least this is the most positive spin I can put on such curious partial disclosure.

Free Energy - Freie Energie - energia libre - OverUnity.com · « **Reply #8733 on:** November 14, 2011, 01:12:33 AM »

Tito L. Oracion · « **Reply #8734 on:** November 14, 2011, 04:44:37 AM »

hmmmm it seems that i smell some hopeless direction here

Qwert · « **Reply #8735 on:** November 14, 2011, 09:08:00 AM »

Quote from: Haan on November 14, 2011, 12:56:45 AM

Please explain what "bucking mode (back-to-back serial opposing)" and "serial reinforcing mode" mean.

Hi.
I guess, a good (at least a partial one) explanation is here:

http://www.overunity.com/index.php?topic=2300.msg221623#msg221623

"...WHEN TWO TRANSFORMERS ARE OUT OF PHASE WITH EACH OTHER THE SIGNAL IS CANCELLED
, or when they are connected in reverse of one another. (Actually when one FREQUENCY is in reverse of another! INVERTED!)Then you can measure all kinds of things going on.
You can generate all kinds of hash and multiple frequencies, and I do mean all kinds.
What I measured during this process was very interesting.
All these frequencies occasionally..."

Free Energy - Freie Energie - energia libre - OverUnity.com · « **Reply #8735 on:** November 14, 2011, 09:08:00 AM »

Sponsored links:

verpies · « **Reply #8740 on:** November 14, 2011, 01:24:34 PM »

Quote from: baroutologos on November 14, 2011, 12:46:20 AM

Probes as the article say have a large resistance but this is shunted by a capacitance. So indeed a current will flow.

Good find. However it matters whether oscilloscope probes have:
1) a large resistance shunted by a small capacitance
2) a small capacitance shunted by a large resistance

I took apart my scope probe (LC Waverunner) and it has a series 10kohm resistor right at the tip.
The whole probe measured with a DMM has 8Mohm DC resistance.

In any case, if two measurements are made, firstly with the LF winding and secondly with the HF winding, then any frequency peak that "moves" between these two measurements can be attributed to the artifacts of the sensing winding/coil.
Conversely, any frequency peak that "stays" in the same position can be attributed to the core and Transverse Coil (copper strips).

Free Energy - Freie Energie - energia libre - OverUnity.com · « **Reply #8740 on:** November 14, 2011, 01:24:34 PM »

grizli · « **Reply #8741 on:** November 14, 2011, 03:10:59 PM »

Quote from: verpies on November 12, 2011, 05:19:48 PM

@ALL
I think I see another diffence between Aidas/Arunas/Wesley's (AAW) configuration and Tiger's.

Namely, Tiger's configuration seems to use the bilfilar coil connected in bucking mode (back-to-back serial opposing) and AAW's configuration seems to use the bilfilar coil connected in serial reinforcing mode.

The Russian phrase on Tiger's diagram
"All on one core. The HF winding back-to-back on opposite ends of the core.""
and the dots denoting the directions of the bifilar windings on the schematic, seem to imply the above.

CAn you write english translations on tigers shematics ?

Where is output coil ?

there are many coils there , and I do not understands purpose of them, cause on russian

jbignes5 · « **Reply #8742 on:** November 14, 2011, 03:39:05 PM »

I keep hearing that someone else invented this.

Well it was Tesla who invented this and here it is: http://www.teslauniverse.com/nikola-tesla-patents-390,721-dynamo-electric-machine

The problem I see with the current design is it is only half of the system Tesla designed. In Tesla's design it was a rotating machine that made it's own oscillation Through the exciter portion of the device. There are two inputs one on and the other off. These inputs vary back and forth continuing the motion in the same direction around the ring. The first bank of coils on the ring are the generator coils. The exciter field coils around the rotor generator coils present a field for the rotor generator to convert down into very high current. It is a transformer in all effects. When you try to stop the rotor from turning it will generate extra current from that effort. The lines cuts the rotor coils further generating more current in the process. So one could say this is a steady state Device. When you try to stop the rotor you get all kinds of current and that can be used for a motor to help keep the rotor in sync.

The one thing That I have not seen much is the mixing of longitudinal waves that the copper strip is emitting, inside and outside of your device. This is like a surface of water. Then the coils disturbs the surface pulling in more energy into the system through resonance or an inward direction. My thinking is that the north wave is following around the yoke and the south wave is also following around the yoke to. The bifilar is picking up both waves in respect to the north and south and using both to add to one direction based on the split of the coil. This creates a bigger bang for the buck or a fulcrum like effect.

What they have done here is only half of the drive. Check out the parallels to Tesla's work.

verpies · « **Reply #8743 on:** November 14, 2011, 03:43:52 PM »

Quote from: grizli on November 14, 2011, 03:10:59 PM

Can you write English translations on Tiger's schematics ?

Reluctantly

Free Energy - Freie Energie - energia libre - OverUnity.com · « **Reply #8743 on:** November 14, 2011, 03:43:52 PM »

T-1000 · « **Reply #8744 on:** November 14, 2011, 04:03:52 PM »

Quote from: jbignes5 on November 14, 2011, 03:39:05 PM

I keep hearing that someone else invented this.

Well it was Tesla who invented this and here it is: http://www.teslauniverse.com/nikola-tesla-patents-390,721-dynamo-electric-machine

We reinvented the wheel

Like all other inventors around the world. The all credits go to Nicola Tesla!
And of course, the genuine approach of mixing longitudinal waves with common magnetic waves is half work. The second half is nuclear polarization in ferrite core...

News:

User Menu

OU Shop

Kindle Fire

Menu

Ebay offers

new products

water car

Products

ufomovie.info

sky energy

movieclipsfree

Statistics

Great Hosting

Get Monetized

Google Search

Author Topic: Selfrunning Free Energy devices up to 5 KW from Tariel Kapanadze (Read 2014021 times)

Free Energy - Freie Energie - energia libre - OverUnity.com

Free Energy - Freie Energie - energia libre - OverUnity.com

Free Energy - Freie Energie - energia libre - OverUnity.com

Free Energy - Freie Energie - energia libre - OverUnity.com

Free Energy - Freie Energie - energia libre - OverUnity.com

Free Energy - Freie Energie - energia libre - OverUnity.com

Free Energy - Freie Energie - energia libre - OverUnity.com

Free Energy - Freie Energie - energia libre - OverUnity.com

Free Energy - Freie Energie - energia libre - OverUnity.com

Free Energy - Freie Energie - energia libre - OverUnity.com

Make Money Online MoneyWorkHome.com

Ebay offers